HP LaserJet P1005 driver is an application to control HP LaserJet P1005 CB410A personal up to 15 ppm 1200 dpi color print quality monochrom. HP LaserJet 1020 Driver Download Windows, Linux HP LaserJet 1020 driver is an application to control HP Laserjet 1020 14ppm A4 black and white laser printer. Download the cciss driver from HP's open source project repository for the cciss driver. Since this resulting driver is not shipped by Red Hat, it isn't supported. Since this resulting driver is not shipped by Red Hat, it isn't supported.
The cciss driver is documented in the file /usr/src/linux/Documentation/cciss.txt - this covers all aspects of how to use the driver for block and sequential devices. The first thing to note is that by default, the cciss driver will not identify a SCSI tape device when booting the Linux kernel.
Details as to why this is the case can be found in the cciss.txt file - the important thing to note here is that a couple of steps need to be taken so that the tape drive will be seen each time the system is rebooted. Otherwise, attempts to access the tape drive will fail, even though it is correctly attached to the SCSI bus. The first step is to inform the SCSI driver to scan for additional devices (this is referred to in the documentation as engaging the SCSI core.) To do this, edit the file /etc/init.d/boot.local, and add the following lines: for x in /proc/driver/cciss/cciss0-9.
do echo 'engage scsi'$x done After you have finished the edit, reboot the system. In a majority of cases, this should allow the tape drive to be accessed. You can verify that the tape drive is working by running the following command: # mt -f /dev/st0 status This should report that the device is active - if an error is returned, then some additional troubleshooting is needed. First, look at the /proc/scsi/scsi file: # cat /proc/scsi/scsi You should see output similar to the following: Attached devices: Host: scsi0 Channel: 00 Id: 00 Lun: 00 Vendor: HP Model: C7438A Rev: V303 Type: Sequential-Access ANSI SCSI revision: 03 This entry corresponds to an HP StorageWorks DAT tape drive.
The systems root filesystem is located on a disc that is connected to a HP Smart Array Controller. The system worked normal with SLES 11 SP2 and the update to SLES11 SP3 did complete without any issues. However after the reboot of the system the kernel does wait for the root filesystem to appear but this will timeout and fail. The HP Smart Array Controller has one of this PCI IDs: PCI Vendor ID = 0x103C and one of following device IDs 0x3241 = Smart Array P212 0x3243 = Smart Array P410 0x3245 = Smart Array P410i 0x3247 = Smart Array P411 0x3249 = Smart Array P812 0x324a = Smart Array P712m 0x324b = Smart Array P711m Resolution. If the System has SLES 11 SP2 installed it is possible to apply this settings prior the update to SLES 11 SP3.
This will avoid the boot issue after the update to SLES 11 SP3. Disclaimer This Support Knowledgebase provides a valuable tool for NetIQ/Novell/SUSE customers and parties interested in our products and solutions to acquire information, ideas and learn from one another.
Materials are provided for informational, personal or non-commercial use within your organization and are presented 'AS IS' WITHOUT WARRANTY OF ANY KIND.